|
Hot
Tubs On Hire Provides The Spa N A Box Hot Tub
 
Spa
N A Box Hot Tub Specifications & Hire Requirments
Capacity
– 1060 litres
External Diameter – 186cm
Internal Diameter – 164cm
Height – 68cm
Filled weight – 1165
Chemicals
used – Bromine, 002 Oxidiser, PH+ Sodium Carbonate, PH- Sodium
Bisulphate (For more information on chemicals please read labels
carefully which will be left with you at point of hire) You will
also be required to add chemicals each day to keep your hot tub
clear and safe and test the water three times a day. Please see
the section “what you need to do whilst hiring” for
more information.
Bromine
tablets will be left in a dispenser, which will slowly release into
the water throughout your hire.
Time
to reach optimum temperature – Approx 24 hours (To help aid
this in the winter, a steady flow of hot water will need to be provided
from your domestic supply)
 A
suitable water supply will be needed
Electricity
– We will supply all electrical cable up to approx 75ft, rated
at IP54 (weather proof) a standard domestic13 amp power supply will
be required.
Water
– You will need to provide a garden hose pipe, if however
you do not have access to a hose pipe, we can supply one.
Base
or site - A flat level base to site the hot tub or spa, this can
be slabbed, concrete, blocks, decking or any firm hard standing.
Grassed areas are not ideal but in some cases using such as OSB
board (2 x 8ft x 4ft boards) or similar this may be possible, if
the ground is flat level and hard during the summer months a plastic
sheet (which we can supply) could be used but please consult us
for advice.
Exemptions
– Pregnant women should not use hot tubs, children under the
age of 14 are advised not to use hot tubs, the very elderly or people
with health problems or taking medication should consult their doctor
before use
What
You Need To Do Whilst Hiring A Spa N A Box Hot Tub
 Once
we have delivered and installed your spa n a box hot tub,
we will then fill and add the appropriate chemicals ready for you
to use the following day if the optimum temperature has been reached.
We
advise that you test the temperature of the water before you use
the spa
You
will need to test the waters PH levels three times a day whilst
you are renting the hot tub (ph strips will be provided, and you
will be shown what to do on installation)
You
will then need to make a log on a record sheet provided of the PH
level you have tested (this is very simple, you just take a strip
from the pot you will be provided with and match the colour from
the chart on the back of the pot)
If
the PH is too low or too high, then you will need to rectify this
by adding some chemicals that you will be left with. (again this
is very simple you just add ph+ or ph- until the PH levels are at
the guideline of between 7.0-7.6)
You
will also need to add two scoops of oxidiser each day, to keep the
water clean and fresh. (THE PUMP AND BLOWER JETS SHOULD BE LEFT
ON WHEN CHEMICALS ARE ADDED, AND THE HOT TUB SHOULD BE CLEAR OF
PEOPLE)
To
ensure that your hot tub remains working well at the desired temperature,
it is important that you change the filter once throughout a weekend
hire. (A SPARE, CLEAN FILTER WILL BE LEFT WITH YOU IN A BUCKET.
WHEN YOU CHANGE THE FILTER, TURN THE PUMP AND POWER OFF AND LEAVE
YOUR USED FILTER SUBMERGED IN WATER UNTIL COLLECTION)
Now
that you have replaced the filter, the pump will need bleeding before
you switch it all back on. (YOU WILL BE SHOWN AT POINT OF HIRE HOW
TO BLEED THE AIR AND YOU WILL BE LEFT WITH CLEAR INSTRUCTIONS. PUMP
MUST NOT BE ON WHILST BLEEDING) Pumps need to be air bled each time
the hot tub is switched off and then re-started, so it is advised
that you keep your hot tub on during your hire, but turn off the
jets when not in use to maintain the optimum temperature level.
 If
you follow these steps then your experience will be a pleasant and
enjoyable one. These steps are in place to ensure your safety and
the safety of our equipment.
All
you need to remember is the FOUR simple rules which are very easy
to follow once shown:
Test
3 x per day and log result
Add oxidiser everyday
Change filter once on a weekend hire
Air bleed pump after filter change
Take
care of yourself and our equipment throughout your hire
|
FREE Local Hot Tub Delivery & Installation
Need
To Ask A Question?